混凝土攪拌機包括通過軸與傳動機構連接的動力機構及由傳動機構帶動的滾筒，在滾筒筒體上裝圍繞滾筒筒體設置的齒圈，傳動軸上設置與齒圈嚙合的齒輪。那么您知道怎么維護保養它嗎？

The concrete mixer consists of a power mechanism connected with a transmission mechanism through a shaft and a drum driven by a transmission mechanism. A gear ring arranged around the drum body is arranged on the drum body, and a gear engaged with the gear ring is arranged on the transmission shaft. Do you know how to maintain it?

1、保養機體的清潔，機體上的污物和障礙物。

1. Maintain the cleanness of the body and remove dirt and obstacles on the body.

2、檢查各潤滑處的油料及電路和控制設備，并按要求加注潤滑油。

2. Check the oil, circuit and control equipment at each lubrication point, and add lubricating oil as required.

3、每班工作前，在攪拌筒內加水空轉1--到2min，同時檢查離合器和制動裝置工作的可靠性。

3. Before each shift, add water into the mixing drum and idle for 1 - to 2min, and check the reliability of the clutch and brake device.

4、混凝土攪拌機運轉過程中，應隨時檢聽電動機，減速器，傳動齒輪的噪聲是否正常，溫升是否過高，

4. During the operation of the concrete mixer, check whether the noise of the motor, reducer and transmission gear is normal, and whether the temperature rise is too high,

5、每班工作結束后，應認真清洗混凝土攪拌機。

5. After each shift, the concrete mixer shall be carefully cleaned.

此外在減速電機中，裝有合成齒輪油，其數量須根據銘牌要求嚴格控制，如果油量較多或較少，均會對電動滾筒實際運轉造成不良影響。

In addition, the reducer motor is equipped with synthetic gear oil, and its quantity must be strictly controlled according to the nameplate requirements. If the oil quantity is more or less, it will have a negative impact on the actual operation of the electric drum.

在電動滾筒累計運轉時間超過200-300h后，應進行更換，之后每500h更換一次合成齒輪油，在換油的過程中，兩個油塞須同時旋開，同時對滾筒進行旋轉，保證其處在低的位置，直到電機中的油放空為止。

After the accumulated running time of the electric roller exceeds 200-300h, it shall be replaced. After that, the synthetic gear oil shall be replaced every 500h. During the oil change process, the two oil plugs must be unscrewed at the same time, and the roller shall be rotated to ensure that it is in the low position until the oil in the motor is drained.

按照要求對滾筒軸承室中加注潤滑脂，同時還要在絲杠的表面均勻涂抹一層潤滑脂。各臺班結束后，須對滾筒表面、膠帶底面和托輥上的雜物進行清理，防止雜物對設備正常運行造成不良影響。

Fill the roller bearing chamber with lubricating grease as required, and at the same time, evenly apply a layer of lubricating grease on the surface of the lead screw. At the end of each shift, the sundries on the drum surface, the bottom of the tape and the idler must be cleaned to prevent the sundries from adversely affecting the normal operation of the equipment.

混凝土攪拌機的維護保養靠日常的相關內容就講解都這里了，您對此有什么想咨詢的問題可以隨時來我們網站http://www.tywlkj.cn咨詢看看。

The maintenance of the concrete mixer depends on the daily related content. If you have any questions about it, you can come to our website at any time http://www.tywlkj.cn Consult.